OPERATION
1. Place the water cooler on a flat level surface in a cool shaded location near a grounded wall outlet.
2. Position the water cooler so that the back of the unit is a minimum of 4 inches/10 cm away from
the wall to ensure proper ventilation.
3. Place the water bottle on top of the cooler appropriately.
Note: On Hot & Cold models, vent the hot tank by holding the hot faucet open until water flows
out.
4. Ensure that the available power supply matches the cooler's voltage specifications indicated on
the nameplate label (located at the rear). Plug power supply cord into receptacle. Please ensure
that cooler is set up so as access to the power outlet and plug is unobstructed. Turn on heater
switch.
Note: To provide additional protection from the risk of shock, this unit MUST be connected to a
ground fault circuit interrupter (GFCI) outlet at all times. Use of an extension cord will void any
warranties.
5. Do not draw water from the cooler for about 30 minutes to let the water cool or heat. Optimum
water temperatures will be reached after several hours of operation.
6. Ensure the following when cooler is to be serviced:
6.1 Turn off Hot Tank Switch (Hot & Cold models only) and disconnect power supply cord.
6.2 Remove bottle from reservoir.
6.3 Use a bucket to drain water from the cold water reservoir through faucets. On Hot & Cold
models, turn off hot tank switch as above. Allow 1 hour for the hot water to cool down inside
the hot water tank. Remove the drain plug at the rear of the cooler to drain into a container.
CAUTION! ALWAYS DRAIN WATER COMPLETELY
BEFORE SHIPPING OR STORING THE COOLER!
CLEANING
To ensure that the cooler's warranty is not voided and to ensure safe operations of the cooler:
·Never Immerse the Cooler in Water for Cleaning or Any other Reason
·Never Use a Pressure Washer/Power Washing Device to Service, Maintain or Clean the Cooler
·Follow all Instructions in this Manual
External: With the electrical power off, use only mild dishwashing liquid or cleaning products and a soft
cloth for cleaning the exterior surfaces. DO NOT USE bleach or abrasive cleaners. Use a vacuum cleaner to
remove dirt and lint from the condenser. The unit should be cleaned every 3 months, except where fingers
touch the temperature selectors, which can be wiped often with hygienic wipes or mild food grade
disinfecting or cleaning products.
Caution: Do not clean unit with a pressure washer
Internal: In the interest of hygiene it is recommended that the water cooler is cleaned every 6 months.
Please contact your distributor for further information
Caution: This operation should be carried out by properly trained personnel. Only use FDA food grade
approved sanitizing products. The use of these products must be in accordance with the manufacturer's safety
instructions and recommendations.
RECEIVING
Inspect the cooler box immediately and carefully for any evidence of shipping or handling damage before
signing to receive goods. In case of shipping damages, claims should be filed immediately with the carrier.
Please note that the carrier will not accept claims for any damage discovered after signing for
UNINSPECTED GOODS.
Ensure the cooler stands upright for 24 hours before plugging it in.
THANK YOU FOR BUYING A CRYSTAL MOUNTAIN WATER COOLER!
TROUBLESHOOTING
Water Leaks
·If water dripping from above, first try to replace the water bottle
·If water leaking (or not bottle related), unplug Dispenser, remove bottle and contact us at 1-800-878-6422
or send an email to service@crystalcoolers.com for assistance.
Not Cooling
·Optimum cold water temperatures will be reached after several hours of operation
·Ensure that the dispenser is at least 4 inches (10cm) from the wall to provide sufficient ventilation
·High usage may deplete the cold water reservoir faster than the cooler can cool it
·If the water still is not cold, please contact us at 1-800-878-6422 or send an email to
service@crystalcoolers.com for assistance.
To Next Page
Loading...
