Crystal Mountain Avalanche - Receiving and Initial Setup; Inspect for Shipping Damage; Upright Storage Before Plugging In; Cooler Placement and Ventilation

RECEIVING
Inspect the cooler box immediately and carefully for any evidence of shipping or
handing damage before signing to receive goods. In case of shipping damage, claims
should be filed immediately with the carrier. Please note that the carrier will not
accept claims for any damage discovered after the signing for UNINSPECTED
GOODS. Ensure cooler stands upright for 24 hours before plugging it in.
OPERATION
1. Place the water cooler on a flat level surface in a cool shaded location near a
grounded wall outlet. Position water dispenser so that the back of the unit is a
minimum of 2 inches / 5cm away from the wall to ensure proper ventilation
(Figure 1).
2. Place the water bottle on top of the cooler appropriately (Figure 2). For open
reservoir models, the bottle cap needs to be removed.
Note: On H&C models, vent the hot tank by holding the red faucet open until
water flows out (Figure 3). (Heater switch may now be turned on)
3. Ensure that the available power supply matches the cooler’s voltage specifications
indicated on the nameplate label (located at the rear of unit).
Plug power supply cord into receptacle (Figure 4).
Please ensure that cooler is set up so as access to the power outlet and plug is
unobstructed.
Note: To provide additional protection from the risk of shock, this unit MUST be
connected to a ground fault circuit interrupter (GFCI) outlet at all times. Use of an
extension cord will void any warranties.
THANK YOU FOR BUYING A CRYSTAL MOUNTAIN WATER COOLER!
Avalanche
by
Crystal Mountain
On
Cold
Avalanche
by Crystal Mountain
On
Cold
2 inches (5 cm)
Figure 1
Avalanche
by Crystal Mountain
On
Cold
Figure 2 Figure 3 Figure 4