4. Do not draw water from the cooler for about 30 minutes to let the water cool or
heat. Optimum water temperatures will be reached after several hours of operation
(Figure 5 and Figure 6).
5. Ensure the following when cooler is to be serviced.
5.1. Turn off Hot Tank Switch (H&C models only) (Figure 7) and disconnect
power supply cord (Figure 8).
5.2. Remove the water bottle (Figure 9) and drawing water from the reservoir
and hot tank, remembering to cool and drain hot tank. Allow 1 hour for hot
water to cool down inside the hot tank before removing the drain plug
located on the bottom of the cooler to drain into a bucket.
CAUTION! ALWAYS DRAIN WATER COMPLETELY
BEFORE SHIPPING OR STORING THE COOLER.
CLEANING
Do Not Immerse the Unit in Water for Cleaning
Remove the lid and clean any dust or contaminants from the cooler by rinsing the
cold water reservoir and faucets with clean water prior to use. Use only mild
dishwashing liquid detergent for cleaning the exterior surfaces (Figure 10 and
Figure 11). DO NOT USE bleach or abrasive cleaners.
Figure 7 Figure 8 Figure 9
To Next Page
Loading...
