Crystal Inspire 414 - Auto Call Back on Busy; Do Not Disturb DND; Call Forward

Cancellation of DND Lift handset & Dial *720, Get confirmation tone
(11) DO NOT DISTURB (DND) : If you do not want to receive any calls ,you can enable this feature.To do so:
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *721 + xx, Confirmation Tone XX = Self Extension number
3 Hang up,
Now if any other extension calls your extension, he will get error tone
Note:A broken dial tone is always heard on the extension with this feature enabled. However you can
make outgoing calls normally from this extn.
(12) CALL FORWARD :You can forward all calls to any other extension. This is use ful when you are move to some
other extension and do not want unattended your calls. To do so:
Now anyone dialing your number shall be connected to this forwarded extension.
Note: A broken dial tone is always heard on the extension with this feature enabled. However
you can make outgoing calls normally from this extn.
Cancellation of Call Forward Lift handset & Dial *720, Get confirmation tone
(13) BARGE-IN(WITH WARNING TONE) : With this facility you can convey priority message to a busy extension.
To do so:
Step Procedure Tones Abbreviations
1 Lift handseat Internal Dial Tone
2 Dial desired Extension- If busy Busy Tone Busy with intercom or trunk call
3 On Busy tone dial 83 Warning tone to All 2 sec Beep Beep tone before intercept
4 Start conversation
v Barge-in shall not work if the busy extension is in Dialing / Ringing / Conference mode.
(9) CLI (DTMF/FSK SIGNAL) : If you have a caller ID Telephone set, you can avail below three features:
A) Calling extension number display.
B) Caller ID number of incoming call (Round Robin / Simultaneous).
C) Caller ID number of transferred call (Incoming / outgoing)
Step Procedure Tones Abbreviations
1 Lift the handset Internal Dial Tone
2 Dial *721 + xx, Confirmation Tone XX = Extn. No., where calls forwarded
3 Hang up,
Step Procedure Tones Abbreviations
1 Lift the handset Internal Dial Tone
2 Dial desired junction/Extn. Number Busy tone
3 During Busy tone Dial 75 Confirmation Tone
4 Hang up
(10) AUTO CALL BACK ON BUSY : If the dialed junction/extn. is busy, you need not try it again and again. By using
this feature the system will automatically call you when the phone becomes
free. Lift the phone for dialing. To do so.
Inspire 104/206/308/414 User Guide
6