Crystal Inspire 414 - Conference Three Party

Step Procedure Tones Abbreviations
1 Hold the existing caller Music tone to hold caller
2 Dial other extension number Ring tone
3 Reply by other party, consult with him
4 Now Press Flash + Dial 1 for Call Toggle Music tone to hold caller
5 Repeat Step 4 to toggle between both Party
6 Hangup, when conversation is over
(14) CALL TOGGLE : You can toggle between your current call (Intercom / JN) & a 2nd call on hold.
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial desired Extension- If busy Busy Tone Busy with intercom or trunk call
3 On Busy tone dial 80 No Warning tone Now can monitor the call (after 1 sec)
4 Hang up
(15) MONITOR : With this facility you can monitor conversation of two extensions without any indication
(short beeps) to busy extn
1) All three intercom, 2)Two intercom& one JN call, 3) Two JN call & one intercom
(16) CONFERENCE (THREE PARTY) : You can make conference among yourself & other two (either extn. or Jn.).
Proceed as below with different options
When the master extension which had originated conference goes On-Hook, conference will be terminated.
NOTE : While adding extensions/ junction., you may get
A) Busy Tone - Dial Flash + 2 and re-start the process.
B) Error Tone - Dial Flash + 2 and re-start the process.
C) No-Reply - Dial Flash + 2 and re-start the process.
Step Procedure Tones Abbreviations
1 In speech with Extn/Jn
2 Press F (Flash) Key, to put On hold Music tone Music tone to hold caller
3 Dial 2nd Extension / Jn number
4 When extension answer's,
Press Flash Key & Dial " 0 "
5 Three party conference is established
6 Hang up, whenconversation is over
(17) DAY/NIGHT MODE : To set for day / night / auto, landing mode for incoming call
Step Procedure Tones Abbreviations
1 Lift handset Internal Dial Tone
2 Dial *85 + 1/2 for Manual D/N mode Confirmation tone 1= day (D) & 2= night (N) mode
OR
Dial *85 + 3 for Auto D/N mode Confirmation tone
3 Hang up
(18) FLASH TIME : Flash time duration setting of the extension need to program, if flash not responding
properly to operate different user function. Default time set for 600ms of all extension.
To change the flash time, please consult with dealer / installer.
Inspire 104/206/308/414 User Guide
7