CSF Inox CS 40-210 - GOODS TRANSPORTATION, RECEIVING AND TRANSFERRING; SITE PREPARATION

7
3.0 - GUARANTEE
All products manufactured by C.S.F. Inox S.p.A. are guaranteed to the purchaser, for one year from
the date of purchase, against hidden defects in materials or manufacture, providing that they are
installed and used according to instructions and recommendations of the manufacturer.
The guarantee does not cover wear parts or repairs for damage caused by improper use, abrasion,
corrosion, negligence, defective installation, non-observance of inspection and maintenance
operations, use of non-genuine spare parts, accidents or any work carried out by the purchaser
designed to alter the machine's performance as indicated by the manufacturer.
Before returning to C.S.F. Inox S.p.A. any item to be substituted or repaired under guarantee,
inform about the problem the Customer Assistance O󰀩ce and follow instructions of the
manufacturer. Returned items must be properly packed in order to avoid damages during
transport and a technical report describing the defect and how it manifested itself must
accompany the returned item/s.
Any item with a presumed fault should be returned to C.S.F. Inox S.p.A. at the customer's expense,
accompanied by a Declaration of Decontamination (attached to page 46), unless otherwise agreed.
C.S.F. Inox S.p.A. will examine, repair and/or replace the returned piece and then send it back to the
purchaser on ex-works basis.
Should the piece be found under warranty, no further costs will be owed by the purchaser. If, on the
contrary, the fault is not found under warranty, all necessary reparations and replacements will be
charged at normal cost to the purchaser.
C.S.F. Commercial parts incorporated in C.S.F. Inox products are guaranteed by their corresponding
manufacturers.
4.0 - GOODS TRANSPORTATION, RECEIVING AND TRANSFERRING
4.1 - TRANSPORT
The packings of all pumps manufactured by C.S.F. Inox S.p.A. are dened when placing the
order. Unless prior arrangements are made, goods will be packed only for transit conditions and
not for long-term storage; in case it should be necessary to store the pumps outside, you are
requested to cover the pumps appropriately in order to protect the electrical parts (motor) from
rain, dust, humidity etc.
4.2 - DELIVERY
On delivery of the supply it is essential to make sure that the packaging has not been
damaged during transport so that any claims can be made immediately to the carrier.
Should any damage be ascertained, the following procedure must be observed:
Accept the goods with reserve
Take photographic evidence of the damage
Notify the carrier of the damage sustained via registered mail with the photographic evidence
attached.
4.3 - SITE PREPARATION
It is the user's responsibility to:
- Prepare the installation sites as prescribed by local legislation governing health and safety in the
workplace
- Make sure the electrical power supply is compliant with the legislation in force and
possesses an e󰀩cient earthing system.
LIGHTING
The machine installation site must have adequate natural and/or articial lighting in compliance
with the legislation in force in the country of installation.