All-In-One ESS Energy Storage System
1.3.1 This sign indicates a hazardous situation which, if not avoided, could result in death
or serious injury.
1.3.2 The All-In-One must not be touched or put into service until 5 minutes after it
has been switched off or disconnected to prevent an electric shock or injury.
1.3.3 This sign shows danger of hot surface.
1.3.4 Refer to the operating instructions.
1.3.5. Setting of Warning Sign for Safety
During instruction, maintenance and repair, follow the instructions below to prevent non-
specialist personnel from causing misuse or accident:
◆Obvious signs should be placed at front switch and rear-level switch to prevent accidents caused by
false switching.
◆Warning signs or tapes should be set near operating areas.
◆The system must be reinstalled after maintenance or operation.
1.3.6 Measuring Equipment
To ensure the electrical parameters to match requirements,related measuring equipment are
required when the system is being connected or tested.
Ensure that the connection and use matched specification to prevent electric arcs or shocks.
1.3.7 Moisture Protection
It is very likely that moisture may cause damages to the system. Repair or maintaining activities in
wet weather should be avoided or limited.
1.3.8 Operation After Power Failure
The battery system is part of the energy storage system which stores life-threatening high voltage
even when the DC side is switched off. Touching the battery outlets is strictly prohibited. The inverter
can keep a life-threatening voltage even after disconnecting it from the DC and / or AC side.
Therefore, for safety reasons, it must be tested with a properly calibrated voltage tester before an
installer works on the equipment.
1.3 Safety Instructions
1.4 Battery Safety Datasheet
1.4.1 Hazard Information
Classification of the hazardous chemical:
Exempt from classification according to Australian WHS
regulations. Other hazards:
2
To Next Page
Loading...