ELECTRONIC SIGHTS
5
PRODUCT INSTALLATION AND MOUNTING
The CT RAD™ micro Series Sight is intended for use on handgun slides that are
compatible with Shield RMS® or JPoint® footprints. The CT RAD™ micro Series Sight is
compatible with most accessories and interfaces based on the pattern shown below. It is
recommended that an experienced gun smith verify this product’s fit prior to making any
permanent modification to your firearm. Use the following guide to insure the best fit.
WARNING: CONFIRM THAT YOUR SIGHT IS SECURELY AND PROPERLY INSTALLED. AN
IMPROPERLY INSTALLED SIGHT COULD BECOME DETACHED DURING RECOIL CAUSING INJURY.
To Next Page
Loading...