Z45X SERIES INDUSTRIAL CONTROLLERS - DECEMBER 23, 2020 19
Service Name – A name that will be associated with a service advertised on the Quick
Panel of the WAN interface
Forwarding From – The inbound (WAN side) port number managing the traffic
Local Port – The port number on the LAN side that the traffic will be routed to
Local IP – The IP address on the LAN side that the traffic will be routed to. Must be part
of the class C range defined in the Ethernet Interface screen.
Advertise – Yes or no
Protocol – TCP, UDP, or both
Enable – Make the rule active (Yes/No)
RS232/RS485 Ports
The RS232/RS485 screen is used to configure the physical (electrical and timing)
characteristics of the serial ports. The serial ports can be connected to the TCP/UDP
PAD function for WAN transmission or to various protocols used by Automation Control.
See TN039 for details.
RS232/RS485 Options
The screens under this function are used to configure the serial (TCP/UDP/PPP) pad
function. For details see TechNote TN-007
To Next Page
Loading...
Need help?
General