Laser Sky | User Manual 1079V180912
The power to engage
BASIC OPERATIONS
TURNING THE CTOUCH INTERACTIVE DISPLAY ON OR OFF
1. Plug the power cord into an AC power outlet.
2. Switch the Power Switch on, to turn the CTOUCH interactive display on.
3. The display is in standby mode now. Wait a moment until the power indicator lights up, then press to turn on the CTOUCH interactive display.
NOTE: Be sure to wait for a few seconds before pressing button. If you promptly press the CTOUCH interactive display may act wrongly or not respond at all.
4. Press button again to put the display in standby mode.
5. Switch the Power Switch off to cut off the power completely.
FIRST TIME INSTALLATION
When turning on the CTOUCH display for the first time, the below shown installation menu pages will appear on the screen.
Select the desired menu language.
Press START to go to the next page.
Select your location and press NEXT to
go to the next page.
Select your required Energy Saving
Mode and press NEXT to finish the
installation.
To Next Page
Loading...
Need help?
General
