15
Personalise
More Setup MoreSetup Personalise This allows you to set up a two
line message, with up to 40
characters on the display which
will be displayed when the dBbox3 is switched on. A typical use of this would be a
“this unit belongs to” message. It is important to note that when this facility has
been used it cannot be changed without return of the dBbox3 to CTP Systems. The
personalise message may also be disabled if you are concerned someone may find it
amusing to put an alternative message on your dBbox3!
If a personalise message is entered when switched on the dBbox3 will display the
message along with ‘Press any key’ to start the unit.
How to personalise the dBbox3
Setup Personalise
A warning message will come up stating this cannot be undone. Press any key. Read
again, then press any key.
You are now presented with a choice of:
Exit No setup, back to the normal menu.
Disable Disable the personalise facility
Start Start the personalization process.
Use the left/right keys to select as required, then press “Select”.
If you select “disable” you will be presented with “You have selected to delete this
facility, Are you sure?
Using the left/right key select:
No No setup, not disabled, back to the normal menu.
Yes This facility will be disabled and cannot be used in the future.
If you selected “Start” you will have a blank screen with just a down arrow. This is
the current character position. Either press up or down to select a character or move
the arrow to the right to start in the next position and so on. The left and right keys
move the arrow either way and it wraps round to the second line. It’s worth planning
out 2 lines of 20 character positions before proceeding.
To Next Page
Loading...