16
The left key will move the arrow back the other way. If you wish to erase a character
just put in a space (next character up from small “z”). Do not press “Select” until you
have finished your message. You will then be presented with a screen:
Exit This will exit the personalise routine with no change
Save This will save your message and it will be displayed on power
up from now on.
Auto SwitchOff
More Setup MoreSetup Auto Switchoff Auto switch off can be set
over a range of off to 127
minutes. If the unit is on and the time elapses with no buttons on the dBbox3 having
been pressed then the unit will automatically switch to a very low current virtually
off mode. To switch it back on select the power switch to off, wait half a second and
then switch it on again. When the timer is counting down it will be restarted
whenever a button is pressed on the unit so, for example, if it is set to 30 minutes
and after 15 minutes a button is pressed then the timer will set back to 30 minutes.
LED Torch
Press Select and the Up button for one second to switch the LED light on. Press
Select and the Up button again for one second to switch it off.
USB
The dBbox3 has a mini USB connector for external power and to update the
firmware. Any USB outlet may be used to power the device, a computer or
even an iPhone mains adaptor using the correct mini USB lead.
Firmware updates will be available on our website, please see:
http://www.ctpsystems.co.uk/support.html
All new firmware may be downloaded from here along with instructions and
drivers.
To Next Page
Loading...