10
USERS HANDY TROUBLE-SHOOTING GUIDE
What you see What to do
No picture Check monitor power switch, and cable
Maximize brightness and contrast.
"No Signal Input" is displayed Check signal cable
on screen Is the PC on? Is the video card working ?
Wavy Picture Remove nearby hi-frequency electronic devices, TV/
radio, transmitter, etc
Call service personnel when:
A. The power cord or plug is damaged or frayed.
B. Liquid has been spilled into the monitor.
C. The monitor does not operate normally when operating instructions are observed.
D. The monitor has been dropped or the cabinet has been damaged.
USERS SPECIFICATIONS
Picture Tube: 43.1cm/17 inches(Viewable 40.6cm/16"), 0.27mm(Mask) Dot
Pitch
Scan Freq.: 30~70 KHz, Horizontal,
50~130 Hz, Vertical
Resolution: 1280x1024 (60Hz), maximum
Power Supply: AC 100V-120V/200V-240V, 50/60Hz (Automatic)
Power Consumption: 95W (<8W in power-saving mode)
Plug & Play DDC 1 / DDC 2B
Degussion Automatic
Dimension: 412 (W) x 370 (H) x 417 (D)mm
16.2(W) x 14.6(H) x 16.4(D) inches
Weight: 15.5 Kgs/34.1 lbs
Environmental: Operating Temperature 5°C to 35°C
Humidity 20% to 80%(Non condensing)
Storage Temperature -20°c to 60°C
Humidity 10% to 90%(Non condensing)
Note:Specifications are subject to change without notice.
To Next Page
Loading...
