DRIVING THE TRACTOR
1nternational Cub Cadet 1250, 1450, and 1650 Tractors
STARTING THE TRACTOR NOTE: Never operate engine with release lever in
(UP) position. Towing or pushing the tractor for
more than a few feet may result in transmission
damage.
1. Depress the brake pedal and release the brake
lock. Move the throttle lever to the position where
the engine operates best for the load to be handled.
2. Start the tractor in motion by moving the speed
control lever slowly forward or rearward as
described above.
STOPPING
THE TRACTOR
Move the speed control lever to the "N" position
or use the brake. Before dismounting always lock
the brake pedal and turn the ignition "OFF". Also,
disengage the power take-off clutch lever.
RELEASE lEVER
To push or move the tractor for a short distance,
the release lever, located on the right side of the
frame near the cam stop, must be held in the (up)
position and the speed control lever must be in the
"N" position.
CAUTION! To prevent injury or an
accident, do not carry passengers or give
rides. Keep children, pets, and by-
standers out of the area.
The lift handle is used to lift or lower equipment
used with the tractor. The equipment can be set in
multiple positions by depressing the button on the
top of the handle and releasing it when the desired
position is reached.
Lock cam into this position by turning knobclockwise.
If free handle travel between cam stop and fully
raised position is desired (Float Position), depress
the release button on top of the handle, press in
the lock button located at the front of the handle
and release the top button.
HEIGHT ADJUSTMENT
If a single implement height is normally used, the
handle may be adjusted to locate the desired
position by use of the cam stop.
NOTE: To disengage the lift handle from the float
position, pull lift handle back slightly and depress
top button.
With lift handle in desired implement height
position, release cam by turning locking knobcounterclockwise.
Turn cam until it contacts tang.
NOTE: Refer to the equipment manual for proper
hitching instructions.
14
To Next Page
Loading...
