Cub Cadet 1872

Essential safety guidelines for operating and maintaining equipment.

Specifications for tightening nuts and bolts in foot-pound units.

Specifications for tightening nuts and bolts in Newton-meter units.

Critical safety instructions to prevent injury and ensure safe operation.

Detailed torque values for various nuts and bolts in Newton meters.

Guides for removing various engine models, including Briggs & Stratton, Kohler, and Onan.

Comprehensive steps for removing and reinstalling the 20 HP Onan engine.

Detailed steps for removing the 18 and 20 HP Kohler engines from the tractor.

Torque specifications for various chassis components and assemblies.

Detailed instructions for maintaining and repairing the power steering system.

Guides for adjusting the brakes on garden tractors.

Torque requirements for components within the gear drive system.

Torque requirements for components within the hydrostatic drive system.

Torque values applicable to general mechanical components.

Step-by-step procedures for disassembling the power steering kit.

Guidelines for preparing for troubleshooting and initial checks to perform.

Specific troubleshooting steps for hydraulic system components.

Common noise complaints and steering problems with their potential causes.

Troubleshooting high steering effort and lost motion in the steering system.

Diagnosing and addressing problems related to excessive heat in the system.

A chart detailing torque values for specific components.

Essential steps before starting disassembly and critical safety warnings.

Instructions for securing the unit and removing the plug assembly.

Steps for safely removing the port cover and its related hardware.

Procedures for removing various valve components like springs, rings, and the manifold.

Guidance on inspecting springs and the port manifold for wear or damage.

Inspecting the valve plate and hex drive assembly for proper condition.

Inspecting the isolation manifold and drive link for wear or damage.

Steps for removing the metering ring and the commutator seal.

Inspecting the commutator cover for scoring or damage.

Steps for installing the commutator seal and removing the retaining ring.

Removing a worn bushing and inspecting bolts.

Detailed steps for removing the port manifold and its springs.

Steps for removing the valve ring and the valve plate.

Procedures for removing alignment pins and the isolation manifold.

Procedures for removing the commutator cover and its cap screws.

Steps for installing the commutator ring and cap screws.

Procedures for removing the retaining plate and the shaft/wheel tube.

Instructions for replacing seals and O-rings during assembly.

Procedures for assembling new bushings and placing bolts into the fixture.

Installing the upper cover and retaining ring with associated washers.

Steps for installing the input shaft and wheel tube assembly.

Aligning the commutator concentrically and tightening drive plate screws.

Installing the metering ring and bearing spacer.

Installing the upper cover plate, seal spacer, seal ring, and seal.

Assembling the metering package with its spacer and installing the commutator.

Lubricating the commutator and installing the commutator ring.

Installing the commutator seal and alignment pins.

Installing the drive link and checking rotor movement.

Installing the bearing and the metering package.

Detailed steps for installing various seals and back-up rings.

Steps for correctly installing the commutator onto the rotor.

Installing the commutator cover and its cap screws.

Stacking and installing the isolation manifold components.

Troubleshooting common problems such as the tractor not moving or moving slowly.

Troubleshooting problems related to PTO engagement and disengagement.

Diagnosing why the engine stops when the PTO is engaged.

Troubleshooting PTO engagement when hot and engine run issues when PTO is engaged.