Cub Cadet 1405 - Stopping the Tractor

STOPPING THE TRACTOR
A CAUTION
Always engage brake pedal lock, lower
equipment and shut off engine before
dismounting. Never try to start engine from
ground.
Fully depress brake/clutch pedal. When tractor has
stopped, raise brake/clutch pedal slightly and place
gear shift lever in neutral ("N").
Before dismounting, always engage the brake pedal
lock and turn the ignition "OFF." Also disengage the
PTO switch.
OPERATING THE FRONT POWER TAKE-OFF
CLUTCH (PTO) (Refer to Figure 11.)
1. Move the throttle lever back to the medium or
"SLOW" position.
2. Place the speed control lever in neutral ("N").
3. Move PTO switch to "OFF" (A) position. Pull
knob out and lift up to "START" (B) position and
release.
4. Advance throttle to operating speed (full speed).
5. The operator must remain in tractor seat at all
times. If operator should leave tractor seat
without turning off the power take-off switch, the
PTO will disengage.
6. PTO switch must be in the "OFF" (A) position
when shifting the tractor into reverse or the PTO
will disengage automatically. To re-engage the
PTO, shift unit into neutral. Move PTO switch to
"OFF" (A) position. Then pull knob out and lift up
to "START" (B) position and release.
14