Cub Cadet 1535 - Page 12

HOOD AND SIDE PANELS
The tractor hood is arranged to swing up and forward
for easy access to the engine compartment. (See Fig¬
ure 12.) Whenever engine maintenance is required,
the side panels can be removed.
1. Side Panel (One On Each Side)
2. Hood
▲ WARNING
If engine is hot, use caution not to burn your¬
self when removing the side panels.
To remove either right or left side panel, proceed as
follows: Engage the brake lock and raise the lift han¬
dle. Raise the hood. Refer to Figure 13 and at rear of
side panel remove wing nut and flat washer.
Remove front snaps by applying pressure to side of
grille and gently pulling on side panel until snaps pop
out of grille side flange. (See Figure 14.)
■ ^NOTE
Be sure both top and bottom snaps have
popped out.
Figure 13
1. Wing Nut
2. Flat Washer
3. Side Panel
Figure 14
1. Snap
2. Grille
3. Side Panel
4. Grille Side Flange
12