7
• Insert the curved end of chute tube into the hole in
the grass bag cover as shown in Fig. 2-11.
• Insert the lower end of the chute tube over the
discharge chute so that its two notches fit into the
two corresponding notches on the discharge chute.
See Fig. 2-12.
• Secure by placing the ends of the two short retainer
straps on the discharge chute over the pins on the
chute tube.
Bagger Usage
Your triple bagger kit is a valuable accessory to your
tractor. Optimize its performance by operating it correctly.
NOTE: Model 190 Triple Bagger Kit is designed for use
on Fast Attach™ compatible tractors equipped with 50-
inch cutting decks only. This will NOT mount, nor operate
safely or properly on any other tractor regardless of the
tractor’s compatibility with similar accessories.
When all grass bags are full, place the tractor on a
firm, level surface, disengage the PTO, turn the tractor
engine off and set the parking brake.
• Flip Seat up.
• Open the grass bag cover by lifting the cover up. Do
not remove the chute tube assembly from the tractor.
• Remove the grass bags by lifting these up and mov-
ing the bags away from the support tube assembly.
• Empty the grass clippings at a proper disposal site,
use the handle at the bottom of each grass bag.
Holding the bag firmly, empty the contents
• Replace grass bags, close lid, flip down seat, restart
your tractor and resume cutting your grass.
NOTE: Under normal usage, the grass bags are subject
to wear and tear. Check these bags periodically and
wash with water if dirty. Allow to air-dry; do not apply
heat.
Figure 2-11
Assembly
And
Operation
2
NOTE:
Model 190 Triple
Bagger Kit is designed
for use on Fast Attach™
compatible tractors
equipped with 50-inch
cutting decks only.
This will NOT mount,
nor operate safely or
properly on any other
tractor regardless of the
tractor’s compatibility
with similar accessories.
Figure 2-12
Align notches
To Next Page
Loading...
Need help?
General
