Cub Cadet 528 SWE User Manual

18
6
Maintaining
Your Snow
Thrower
WARNING
Always stop engine,
disconnect spark
plug, and ground
against engine before
cleaning, lubricating
or doing any kind of
maintenance on your
machine.
Figure 24
Auger Belt
1. Roll auger belt off the pulley as shown in Figure 23.
2. a. Turn the shoulder screw a half a turn and slide it out
of the mounting bracket. See Figure 24.
b. Unhook spring to release tension on the auger belt.
See Figure 24.
3. Remove old belt and replace with new belt wrapping it
around the auger pulley. See Figure 25.
4. Re-insert shoulder screw into the mounting bracket
and tighten to secure.
5. Wrap auger belt behind the idler. Reattach the spring
to the bolt where it was earlier secured.
6. Re-install frame cover and flip the snow thrower back
to the operating position.
7. Re-install auger belt around the engine pulley.
8. Re-install belt cover with the self-tapping screws
removed earlier.
Figure 25
Figure 23



Cub Cadet 528 SWE Specifications

General

Engine Type	4-cycle OHV
Engine Displacement	277cc
Clearing Width	28 inches
Intake Height	21 inches
Auger Diameter	12 inches
Speeds	6 forward / 2 reverse
Stages	Two-stage
Auger Material	Steel
Impeller Diameter	12 inches
Start Type	Recoil
Throw Distance	40 ft
Starter	Electric
Fuel Tank Capacity	5 qt
Skid Shoes	Adjustable
Warranty	3-year limited
Chute Rotation	200°