Cub Cadet BV 228 User Manual

769-07543 P00 01/12
NEED HELP? CALL 1-877-282-8684 IN U.S. OR 1–800–668–1238 IN CANADA
BV228 EC
2-Cycle
Electric Start Capable
Handheld Blower / Vacuum
IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
9
Upper Blower Tube
Removing Unit From Carton
A
ssemble The Unit
Insert the upper blower
tube into the blower outlet
and turn it clockwise until
i
t locks into place.
I
nstall the lower blower tube
o
nto the upper blower tube
a
nd turn it clockwise until it
l
ocks into place.
S
tarting The Unit
Assemble The Unit
P
lace the unit on a level
s
urface. Fill the fuel tank.
C
rouch in the starting
position.
S
queeze and hold the
throttle for all further steps.
P
ull the rope 5 times.
Move the choke lever to
Position 2.
11 2
Remove all contents from
carton.
5
18
3
S
tarting The Unit
10
11
Need Help?
Call 1-877-282-8684
DIDN’T START?
Repeat the starting instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to the
operator’s manual for additional starting
and troubleshooting information
Mix thoroughly in a separate
fuel can:
– 2.6 fl. oz. of 2-cycle
e
ngine oil
– 1 gallon of unleaded
g
asoline
N
OTE: Do not mix directly in
the fuel tank.
4
Starter Rope
O
n/Off Stop Control
Lower Blower Tube
T
rigger
Handle
C
ruise Control
S
tarting The Unit
Fuel Cap
P
rimer Bulb
Choke Lever
L
ower Vacuum Tube
U
pper Vacuum Tube
V
acuum Elbow
V
acuum Bag Strap
Cinch Strap
Vacuum Bag
Z
ipper
A
ir Filter
Cover
Muffler
Cover
S
park Plug
Tools Required:
• Flathead Screwdriver
1
Gallon 2.6 oz
50:1
Press the primer bulb 10
times, or until fuel is visible.
M
ove the choke lever to
P
osition 1.
16
7
5 X
Continue to squeeze the
trigger, or press down the
cruise control, and allow the
unit to warm up for 30-60
seconds.
Continue to squeeze the
trigger. Move the choke
lever to Position 3. Warm
the unit for an additional 60
seconds. The unit may be
used during this time.
14
Continue to squeeze the
trigger. Pull the rope 3-5
times to start the engine.
12
3-5 X
113
10 X
Primer
B
ulb
Choke Lever
Español — Page 11
English — Page 1
Français — Page 5
Operator’s Manual

Cub Cadet BV 228 Specifications

General

Brand	Cub Cadet
Model	BV 228
Category	Lawn and Garden Equipment
Language	English

Summary

FASTGUIDE ASSEMBLY AND STARTING

Removing Unit From Carton

Instructions for unpacking the blower/vacuum unit from its original carton and verifying all contents are present.

Assembling the Unit

Step-by-step guide for connecting blower tubes, vacuum tubes, and vacuum bag to the main unit.

Starting the Unit

Procedure for preparing and starting the gasoline engine, including fuel, choke, and primer bulb operation.

SERVICE AND SAFETY INFORMATION

Service Information Overview

Provides details on service, assembly, operation, maintenance, and contact information for support.

Rules for Safe Operation

Essential safety guidelines and warnings for operating gasoline-powered handheld equipment.

Important Safety Instructions

Key safety warnings and precautions to prevent injury and ensure proper use of the equipment.

ASSEMBLY AND FUELING PROCEDURES

Unit Assembly Steps

Detailed instructions for assembling the blower tubes, vacuum tubes, and vacuum bag.

Oil and Fuel Mixing

Guidelines for correctly mixing gasoline and 2-cycle oil for optimal engine performance.

STARTING AND OPERATING THE UNIT

Engine Starting and Stopping

Comprehensive procedure for starting, warming up, and safely stopping the engine.

Unit Handling and Cruise Control

Proper grip, posture, and use of the cruise control feature for comfortable operation.

OPERATING MODES AND MAINTENANCE

Operating as Blower or Vacuum

Instructions on using the unit for blowing debris and vacuuming light materials.

Maintenance and Adjustments

Guidance on air filter cleaning, spark plug checks, and idle speed adjustments.

TROUBLESHOOTING AND SPECIFICATIONS

Common Engine Problems

Diagnosing and solving issues like engine not starting, idling, or lacking power.

Technical Specifications

Key technical data including engine type, displacement, RPM, and capacities.

LIMITED WARRANTY INFORMATION

Obtaining Warranty Service

Instructions on how to get warranty service, including required proof of purchase.

Warranty Limitations and Exclusions

Details on what is not covered by the limited warranty and conditions that may void it.