EasyManuals Logo

Cub Cadet CC 760 ES User Manual

Cub Cadet CC 760 ES
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12 Section 4 — controlS and FeatureS
Ignition Switch (Electric Start Models Only)
WARNING! Never leave a running machine
unattended. Always disengage blades, stop engine
and remove key to prevent unintended starting.
Stop
Position
Start
Position
Run
Position
Figure 4-2
The three-position switch is used to start and stop the engine on
electric-start models. See Figure 4-2. To start the engine, insert
the key into the ignition switch and turn clockwise to the START
position. Release key into the RUN position once the engine has
started. Turn the key to STOP to stop the engine.
CAUTION: Never move the key into the START
position while the engine is running; doing so may
cause damage to the engine’s starter.
Drive Control
Located on the left-hand handle, the
drive control is used to engage and
disengage drive to the wheels. To
engage this control, squeeze the drive
control against the handlebar grip. To
stop the drive, release the drive control.
CAUTION: Always release
the drive control before
changing speeds. Failure to
do so may result in serious
damage to your
transmission.
Blade Control
Located on the right-hand handle, the
blade control is used to engage the
mowing deck. To operate, press and
hold the lever against the handlebar
grip. To stop the blades, release the
blade control.
WARNING! Never
attempt to start the engine
with the blade control
engaged.
CAUTION: Always release
the blade control when
starting the engine. Failure
to do so may result in
premature wear to your
engine’s electric starter.
Gear Shift Lever
Use this lever to select any of four Forward ground speeds,
neutral, or reverse.
Forward
Four Forward speeds are available. Position one (1) is the slowest
and position four (4) is the fastest.
Reverse
To select reverse, put the lever in the Reverse (R) position.
WARNING: Look behind the mower before and
during reverse operation. Stop the mower blades
before operating in reverse.
Neutral
Place the lever in neutral (N) before starting the mower, and
when the mower is not in use. In addition, the mower can be
manually pushed or pulled by placing the gear shift lever into
neutral (N) position and pressing the drive control against the
handlebar grip.
CAUTION: Always release the drive control before
changing speeds. Failure to do so may result in
serious damage to your transmission.

Other manuals for Cub Cadet CC 760 ES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet CC 760 ES and is the answer not in the manual?

Cub Cadet CC 760 ES Specifications

General IconGeneral
Drive SystemSelf-Propelled
Drive ControlVariable Speed
Deck MaterialSteel
Mulching CapabilityYes
Bagging CapabilityYes
Side Discharge CapabilityYes
Wheel Size (Front)8 inches
Start TypeRecoil
Cutting Height Range1.5 to 3.5 inches

Related product manuals