Your Vehicle 7-13
your service center before starting the
engine.
If it’
s impossible to take your vehicle to a
service center before starting it, follow the
steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. If water is present, dry
the air box and replace the filter with a
new filter.
3. Remove the spark plugs.
4. Turn the engine over several times.
5. Dry the spark plugs and reinstall them, or
install new plugs.
6. Attempt to start the engine. If necessary,
repeat the drying procedure.
7. Take the vehicle to your service center
for service as soon as possible, whether
you succeed in starting it or not.
8. If water has been ingested into the CVT,
make sure inspect the hole without water
left inside. If it is muddy water, open the
CVT cap and wash the parts before
reassemble.
9. Check the gearshift, release the water
inside. Wash it if it is necessary.
CAUTION：
Make sure all moving parts are coated
with grease after washing and reassemble.
To Next Page
Loading...
Need help?
General