General
Information
1‐8
Observe the following when installing
snap rings:
1.
Remove and install snap rings
with snap rings pliers. Refer to
Basic Tools in this chapter.
2.
In some applications, it may be
necessary to replace snap rings
after removing them.
3.
Compress or expand snap rings
only enough to install them. If
overly expanded they lose their
retaining ability.
4.
After installing a snap ring. Make
sure it seats completely
5.
Wear eye protection when
removing and installing snap
rings
E-clips are used when it is not practical
to use a snap ring. Remove E-clips with
a flat blade screwdriver by prying
between the shaft and E-clip. To install
an E-clip, center it over the shaft groove
and push or tap it into place.
Shop Supplies
Lubricants and Fluids
Periodic lubrication helps ensure a long
service life for any type of equipment.
Using the correct type of lubricant is as
important as performing the lubrication
service. The following section describes
the types of lubricants most often
required. Make sure to follow the
recommendation for lubricant types.
To Next Page
Loading...
Need help?
General
