Cub Cadet Challenger Series User Manual

Engine Management System
7‐4
 Avoid applying lubricant over the director plate holes – this may restrict injector
flow. Do not dip the injector tip in lubricant.
 Multec 3.5 injectors come from the factory with the seal rings attached. The re-
use of seal rings is not preferred when replacing an injector. If an injector is to be
re-used, and no new seal rings are available,
take care to inspect each seal ring
for signs of damage. Even minor defects in the seal ring can lead to leakage.
Take extra care in installing seal ring over the flange of an injector inlet.
 Carefully installing the harness connector will prevent terminal damage. Listen for
a positive audible click from the connector retention device — this ensures that it
is fully engaged. Shut off the ignition.
 Disconnect negative battery cable to avoid possible fuel discharge if an accidental
attempt is made to start the engine.
 Disconnect the electrical connector from the injector wiring harness.
 Relieve fuel pressure.
 Remove the retaining clip from the fuel injector.
 Remove the fuel line connection from the injector.
 Carefully clean debris from the interface surfaces. Do not damage seal mating
surfaces.
 Remove the injector from the manifold.
 Apply a light coating of a lubricant to both the upper and lower injector seal ring of
the replacement injector.
 Install the new injector into the manifold. Check that the injector is installed in the
original orientation to maintain proper spray targeting, and that the retaining clip is
properly seated on the injector and the fuel line.
 Install the retaining clip after connecting the fuel line.
 Tighten the injector mounting to the desired torque as mentioned in the
manufacturer manual.
 Tighten the fuel line.
 Re-install the injector electrical connector.
 Check for fuel leaks with the key “on” and the engine “off”.
 Start the engine and verify proper operation.
 Check the orientation of the spray pattern, do not rotate the injector in the fuel
rail assembly to install the injector electrical connector. This may damage the
retaining clip and result in an improper spray pattern.

Cub Cadet Challenger Series Specifications

General

Brand	Cub Cadet
Model	Challenger Series
Category	Utility Vehicle
Language	English