EasyManuals Logo

Cub Cadet LT1045 User Manual

Cub Cadet LT1045
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
SECTION 9: OFF-SEASON STORAGE
Clean and lubricate the tractor as instructed in Section 7:
MAINTAINING YOUR LAWN TRACTOR on page 19 of this
manual before storing for an extended period.
Engine
If the engine will be out of service for two months or
more, use the following storage procedure:
Clean the exterior surfaces of the engine.
Change the oil and filter while the engine is still
warm from operation. Refer to Changing the Engine OIl
on page 20.
The fuel system must be completely emptied, or the
gasoline must be treated with a fuel stabilizer such
as STA-BIL
®
to prevent deterioration. If you choose
to use a stabilizer, follow the manufacturers
recommendations, and add the correct amount for
the capacity of the fuel system. Fill the fuel tank with
clean, fresh gasoline. Run the engine for 2- to 3
minutes to get stabilized fuel into the carburetor.
To empty the system, run the engine until the tank
and system are empty.
WARNING: Allow engine to cool.
Extinguish cigarettes, cigars, pipes, and other
sources of ignition prior to draining fuel. Drain
fuel only into an approved container outdoors,
away from an open flame.
Remove the spark plug. Add one tablespoon of
engine oil into the spark plug hole. Install the plug,
but do not reconnect the plug wire. Crank the
engine two or three revolutions.
Store the engine in a clean, dry place.
WARNING: Never store the machine or
fuel container indoors where there is an open
flame, spark or pilot light such as on water
heater, furnace, clothes dryer or other gas
appliance.
SECTION 10: MAINTENANCE SCHEDULE
Before
Each Use
After Initial
24 Hours
Every
10 Hours
Every
25 Hours
Every
100 Hours
Every
Season
Prior
to Storing
Clean Hood/Dash Louvers
Check Engine Oil Level
Clean and Re-oil Air
Filter’s Foam Precleaner
Replace Air Filter Element
Change Engine Oil & Filter
Clean Battery Terminals
Lube Front Axles and Rims
Clean Engine Cooling Fins
Lube Front Deck Wheels
Lube Deck Spindles
Lube Pedal Pivot Points
Check Spark Plug

Other manuals for Cub Cadet LT1045

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet LT1045 and is the answer not in the manual?

Cub Cadet LT1045 Specifications

General IconGeneral
Engine BrandKohler
Engine ModelCourage
Engine Power20 HP
Cylinders2
TransmissionHydrostatic
DriveRear-wheel drive
Blades2
Deck MaterialSteel
Turning Radius18 inches
Speed5.2 mph forward/2.3 mph reverse
Cutting Width46 in
Cutting Height1.5 - 4 inches
Warranty3 year / 120 hour (whichever occurs first)

Related product manuals