Cub Cadet SLTX1054 - Lubrication Points; Front Wheel Lubrication; Pivot Points & Linkage Lubrication; Deck Wheel Lubrication

Attach the hose coupler to the water port on your decks 4.
surface. See Fig. 6-2.
Turn the water on.5.
6.
the engine and place the throttle lever in the FAST (rabbit)
position.
7.
8.
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
9.
position.


Turn the water off and detach the hose coupler from the  


cutting deck.


running for a minimum of two minutes, allowing the underside
of the cutting deck to thoroughly dry.
Lubrication
Before lubricating, repairing, or

brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel axles and rims is equipped with a

grease applied with a grease gun after every 25 hours of tractor
operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Deck Wheels

a grease fitting. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor
operation.


21se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s