Cub Cadet SLTX1054 - Hydrostatic Transmission Care; Battery Maintenance; Tractor Cleaning; Smart Jet Deck Wash System



Remove the oil fill cap/ dipstick from the oil fill tube.4.
5.
oil drain port. Route the opposite end of the hose into an
appropriate oil collection container with at least a 2.5 quart
capacity, to collect the used oil.
The engine is equipped with either a twist-and-pull drain 6.
port or a tabbed drain port. If your engine has the twist-
and-pull drain go to step a. If your engine is equipped with
the tabbed drain go to step b.
Turn the oil drain valve a. ⁄-turn, then pull outward to
begin draining oil. After the oil has finished draining,
push the end of the oil drain valve back in and turn
⁄turn to secure it back in place Re-cap the end of
the oil drain valve to keep debris from entering the
drain port.
b.
outward to begin draining oil. After the oil has
finished draining, push the end of the oil drain valve
back in, until the tabs click into place. Re-cap the end
of the oil drain valve to keep debris from entering
the drain port.
7.
Manual.
8.
Manual for information regarding the volume and weight
of engine oil.
Air Cleaner
Service the pre-cleaner and cartridge/air cleaner element as

Spark Plug
The spark plug should be cleaned and the gap reset once a

and gap specifications.
Hydrostatic Transmission
The hydrostatic transmission is sealed at the factory and is
maintenance-free. The fluid level cannot be checked and the
fluid cannot be changed.
Battery
!
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
The battery is sealed and is maintenance-free. Acid levels cannot
be checked and fluid can not be added.
Always keep the battery cables and terminals clean and 
free of corrosive build-up.
After cleaning the battery and terminals, apply a light coat 
of petroleum jelly or grease to both terminals.
CAUTION: If removing the battery for cleaning,
disconnect the NEGATIVE (Black) wire from its

When re-installing the battery, always connect the

NEGATIVE (Black) wire. Be certain that the wires are
connected to the correct terminals; reversing them

alternating system.
Cleaning the Tractor
Any fuel or oil spilled on the machine should be wiped off


part of the machine, especially the belts and pulleys.
Smart Jet

part of its deck wash system.

underside and prevent the buildup of corrosive chemicals.

Drive the tractor to a level, clear spot on your lawn, near 
enough for your garden hose to reach.
CAUTION: 
chute is directed AWAY from your house, garage,
parked cars, etc.
2.
and stop the engine.



20 se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s