19se c t i O n 5 — ba g g e r as s e M b l y & in s t a l l a t i O n : tw i n up p e r ba g g e r cO M p O n e n t s
Peel the backing off of the self-adhesive foam strip (721-9.
04388) that has been included with your grass collector.
Apply it to the upper chute, flush against the flange as
shown in Fig. 5-13.
With the grass catcher cover open, install the discharge 10.
chute over the chute extension tube, as seen in Fig. 5-14,
and rest the top end into the upper chute support installed
on the right-hand side of the bag support assembly. See
Fig. 5-15.
Note: The groove on the upper chute should be aligned
with the upper chute support, as seen in the inset of Fig.
5-15.
Figure 5-15
Figure 5-14
Figure 5-13
To Next Page
Loading...
