© CUB CAMPERS • 2.2 OWNER’S MANUAL V2 • 20/12/2022 PAGE 28 of 32
9. SERVICING YOUR CUB CAMPER
Important - Please Note: It is essential that wheel nuts be re-torqued after an initial
run-in period. The wheel nut tension must be re-checked after the first 100 km of
operation and every 100kms for the first 400kms and thereafter check wheel nuts
before each trip. The recommended torque is 145Nm.
Regular servicing of your camper trailer should be undertaken at no less than 12-
month intervals, but it is highly recommended that you have your camper serviced
after any extended journey, prior to any further extended travelling. Regular
servicing should include checking tyres for wear and correct pressure, bearings
(inspect, re-pack or replace), suspension, brakes (if fitted), tail lights, safety chain/s,
tow hitch, all other fixings.
Details regarding Alko Periodic Maintenance Schedule can be found in the back of
the “Electric Braked Axles” booklet, but after the initial 300km to 1000km service they
are recommended every 10,000 kms or annually.
Servicing should only be undertaken by suitably qualified technicians.
If any guidance is required, please contact your local Cub Campers dealer.
WARNING: IF THERE IS EVER A NEED TO REPLACE THE GAS STRUTS ON YOUR
CAMPER, THIS SHOULD ONLY BE UNDERTAKEN BY A TRAINED TECHNICIAN.
To Next Page