Cubert S185 - Connecting the Control Cable (Optional); Mounting the Camera; Mounting the Tilted Mirror (Optional)

7
www.cubert-gmbh.de
4.3 Connecting the control cable (optional)
The 4-poled jack at the rear of the camera can be used to enable external
trigger capabilities of the camera. Please use an M8 4-pin connector.
The camera will trigger on an 11V-30V/6-10mA pulse. The pins of the
trigger port are used as follows:
4.4 Mounting the camera
For mounting the camera it has a M5 screw socket at the lower planar surface. In order to avoid accidental
camera release, use a screw lock. Additionally, we recommend securing the camera by implementing a
back-up fixation to a UAV with a wire loop.
4.5 Mounting the tilted mirror (optional)
If your camera comes with the optional tilted mirror, you can attach it with four M2x4mm screws.
Figure 1 M8 4-pins connector
M8 4 pins
1
2
3
4
n.c.
n.c.