CuddeLinkManual
Version 2.20.2017 Page 11 of 24
It is good practice to enable CL LEVEL while next to a deployed camera, and then move
away from that camera with the CL LEVEL displayed. This allows you to monitor the level
as you move farther from the deployed camera.
CL LEVEL can change depending upon vegetation and air conditions. Vegetation, trees,
hills will reduce signal level.
Step 7. CL INFO (Home only)
CL INFO is a special item that only appears only on the HOME camera. CL INFO is used to
verify that remote cameras have been deployed and have connected to the HOME camera.
When CL INFO is displayed press the UP key to display information on each network camera.
Screen 1 is a summary of cameras. It will show CL INFO and the number of cameras on the
network.
<screen shots of the 2 display types>
Press UP and the first camera status will be displayed. Continue to press UP or DOWN to display
the status of each camera. The CL INFO menus allows you to see how many camera are on the
network and what their battery status is. Here is some examples:
1st Screen 2
nd
Screen Explanation
01 / HOME 001 OK 1
st
node is HOME with CL LOC 001. Battery is OK.
02 / CAM 005 OK 2
nd
node is a remote camera with CL LOC 005, battery OK.
03 / CAM 003 LO 3
rd
node is a remote camera with CL LOC 003, battery LO.
CL INFO file. The CL INFO information is also on the HOME camera’s SD card. Click the
file Report.html in the DCIM\400CUDDY folder. Your computers web browser will display a
report that shows detailed status of all cameras on the network.
To Next Page
Loading...
