CuddeLinkManual
Version 2.20.2017 Page 21 of 24
happens you can install a REPEATER outside the building which will relay the images
from the REMOTES to HOME PLUS inside the house.
3. Power the CuddeLink HOME PLUS from the AC Power Adapter and the internal batteries.
HOME PLUS will use the house AC for power, and the batteries when the AC is not
available.
4. Attach the USB cable to the HOME PLUS nodes USB port and the PC’s USB port.
5. Configure the HOME PLUS node as required: Channel, PIN, & CL LOC. Verify the HOME
PLUS is connected to the REMOTE cameras using the CL INFO menu.
6. ARM the HOME PLUS node.
7. Start Trophy Room. Click TOOLS, then PREFERENCES, then set CUDDELINK to ON.
8. Click TEST to verify that everything is setup correctly. This test will verify that the PC can
communicate with the CuddeLink HOME PLUS node and that Microsoft OneDrive is
available.
9. Set the time preferences in Trophy Room. This setting will determine how often the
images are transferred from the HOME PLUS node to the PC, and hence to the Internet.
If you do not require instant awareness of activity, we recommend a 12 hour setting.
10. DONE – that is all you need to do. You can close Trophy Room, but you must leave the
PC powered on. The HOME PLUS node must be powered on and ARMed.
Viewing the Images
CuddeLink images will automatically be copied from the HOME PLUS node to the PC and saved
in the PC user’s OneDrive folder. A special folder called CuddeLink was created to store the
images. The best way to view these images is with Trophy Room. When the CuddeLink mode is
enabled Trophy Room will display the folders in the Navigator.
Managing the Images
Trophy Room has access to 2 locations on your PC for saving images:
D:\Cuddeback\‐TrophyRoomimagearchive
To Next Page
Loading...
