Router Mode
Configure the router
Wired
Wireless
Connect your device to the router’s Wi-Fi using the SSID (network
name) and SSID Password printed on the label at the bottom of the
router.
1. Connect your computer to the router by Wired or Wireless, shown
as below.
3. Router Management screen will appear(Router mode default).
Then set your router network name(SSID) and password.
If your connection type is DHCP , choose Auto Config(DHCP), and click
Save/Apply.
If your connection type is Fixed IP, you need to configure the information
which provided by ISP, then click Save/Apply.
4. If your connection type is PPPoE, you need to choose PPPoE Dial-up,
and input the account and password that ISP provide, then click
Save/Apply.
Note: If the login window does not appear, please refer to FAQ > Q1.
2. Launch a web browser, and enter 192.168.10.1 in the address bar.
Use admin for username and password to log in.
Turn off the Wi-Fi on your computer and connect it to the LAN port of
Cudy router via an Ethernet cable.
Connect to the internet
Connect to the power socket
Modem
Quick Installation
Guide
Turn off the modem, and
remove the backup
battery if it has one.
Turn on the modem and
then wait about 2 minutes
for it to restart.
If your internet connection is through an
ethernet cable directly from the wall instead of
through a DSL/Cable/Satellite modem, connect
the Ethernet cable to the router’s WAN port,
then follow step 4 and 5 to complete the
hardware connection.
Verify that the following LEDs stay on
to confirm the hardware is connected
correctly.
1
3
WAN Port, Connect XDLS/Cable Modem/Ethernet
2
6
Connect the power adapter to the router .
4
5
Enjoy the internet!
admin
admin
OK
Cancel
The server 192.168.10.1 at Cudy WR300 requires a username and
password.
Warnig: This server is requesting that your username and password
be sent in an insecure manner(basic authentication without a secure
connection).
Service Set identfier(SSID):
Pre-Shared Key:
Cudy-XXXX
XXXXXXXXXX
Save/Apply Cancel
Save/Apply Cancel
Cudy-XXXX
XXXXXXXXXX
00:00:00:00:00:00 (XX:XX:XX:XX:XX:XX)
WAN Connection Type:
User Name:
Password:
Clone MAC Address:
Fixed IP Auto Config (DHCP) PPPoE Dial-up
Access Point Router Repeater Repeater WISP Client Client WISP
Cudy-XXXX
XXXXXXXXXX
Cudy-XXXX
00:00:00:00:00:00
(XX:XX:XX:XX:XX:XX)
Service Set identifier (SSID):
Pre-Shared Key:
WAN Connection Type:
Host Name:
Clone MAC Address:
Fixed IP Auto Config (DHCP) PPPoE Dial-up
尺寸：285*210mm 正反面双色打印 80g书写纸 三页风琴折
To Next Page
Need help?
General
