D
D
A
D
B
C
A
A
14
Assembling Dicer in the Work Bowl
1. Place Stem Adapter on hub in bottom of
Work Bowl.
2. Carefully place Dicing Grid onto the Stem
Adapter with the grid positioned closest to
the front of the food processor. Be sure
“This Side Up” shows on top. The cutting
grid should be facing the triangle on front
of the grid and line up with the front center
of the work bowl. Dicer will not work if
inserted incorrectly.
3. Place Dicing Disc on top of grid.
Push down slightly to lock into place.
It should not move if correctly positioned.
NOTE: Always use caution when handling
the dicing blade: It is very sharp.
SECURING THE FOOD
PROCESSOR LID TO THE
WORK BOWL
1. Place the Lid over the Work Bowl with
the lid grips (A) positioned at approximately
1 and 7 o’clock.
2. Lower the Lid onto the Work Bowl, aligning
the locking tabs (B) under the lid grips with
the metal tabs (C) on the bowl.
3. Press Lid down and rotate clockwise.
4. Continue rotating clockwise until you hear
and see the lid locking mechanisms on
bowl handles and lid grips (A) click into
place (D).
NOTE: To remove Lid, simply grip firmly and
turn counterclockwise until lid grips are in the
1 and 7 o’clock position and lift up.
PREPPING
To Next Page
Loading...
Need help?
General
