ASSEMBLY INSTRUCTIONS
12
STEP 7
-----------------------------------------------------------------------------------
• Insert the end of the power cord through the hole in the back panel of the grill.
NOTE: Before plugging your smoker into an electrical outlet, ensure the temperature dial is in the OFF
position.
STANDARD OUTLET
This appliance requires 110 volt, 60hz, 230w, 5 amp service. It must be a 3-prong plug. Ensure grounded
end is not broken off before use. The control used a 5 amp, 120 volt, fast-blow fuse to protect the board
from the igniter.
GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended size of 15 amp service. If your GFCI
outlet is highly sensitive to power surges, it will likely trip during the start-up phase of operation. During the
start-up phase, the igniter draws 200-700 watts of electricity which can be too much power for a GFCI outlet
to handle. Each time it trips, it increases in sensitivity. If the GFCI keeps tripping, replace the outlet or change
to a non-GFCI outlet.
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual start-up procedure. The unit can
operate using a 12 volt, 100 watt inverter plugged into your automobile outlet. To use the automatic igniter, it
is recommended to use a minimum of a 1000 watt inverter.
11
8
To Next Page
Loading...
