14
3. USE
Before using for the rst time we recommend operating
the kettle 2 or 3 times. Fill to the MAX mark ll level (1.7L),
bring to the boil and when boiling has nished and the
kettle has switched o, discard the water and rinse out
the inside.
A. Control Panel
1. On/O Switch
Used to turn the kettle on and o.
2. Button
Used to increase the temperature in increments of 5
degrees from 85°C through to 100°C.
3. 85ºC Button
Temperature setting for coee and varieties of tea (refer
to quick reference guide on page 15).
4. 100ºC button
Temperature setting for boiling water for a variety of teas
(refer to quick reference guide on page 15).
5. Digital display window (LCD)
Displays temperature setting and the water
temperature.
B. Operation
• Open the lid by pressing the lid release button located
on the top of the handle.
• Fill the kettle with the required amount of cold water.
The water gauge is at the rear of the kettle and is
marked with min (0.5L) and max (1.7L) and 2 cup and
4 cup markers.
N.B. Take care not to exceed the max mark as this may
cause spitting or leaking from the spout when boiling.
• Push the lid closed; you will feel and hear a slight
"click".
• Align the kettle over the powerbase and gently lower it
into position, setting it rmly on the base.
• Plug the kettle into the mains; the LCD and water
indicator window on the back of the kettle will
illuminate and the LCD will show the water temperature
in increments of 5 degrees.
N.B. On initial use the LCD window will show the ambient
water temperature.
• Press the 85°C button or the 100°C button.
• If you want to set the temperature manually, press the
"+" button located on the handle. This will increase the
temperature in 5 degree increments from 85°C through
to 100°C. The temperature can only be increased from
a starting temperature of 85°C.
To Next Page
Loading...
