8
Instructions for Use
Before first use, clean the bowl and attachments in warm soapy water.
N.B. Do not clean any of the parts with abrasive cleaners or hard implements.
A Assembling the Stand Mixer
n Raising the Mixer Head
Press down on the release lever and lift the head until it locks into place.
n Fitting and removing attachments
Ensure the mixer head is in the raised position. Attach the flat mixing paddle, chef’s
whisk or dough hook to the accessory port, ensuring the lug on the port aligns with the
gap in the attachment. Support the mixer head with one hand while using the other
hand to push the attachment upwards, turning anti clockwise until it locks. To remove,
push upwards and turn clockwise until the attachment is released.
n Fitting the Work Bowl
Place the bowl on the base and turn clockwise to secure.
n Lowering the Mixer Head
Supporting the stand mixer head with one hand, push down on the release lever and fully
lower the mixer head until it locks into place.
n Attaching the Splash Guard with Pour Spout
After fitting an attachment and lowering the stand mixer head, slide the splash guard
onto the bowl (check the guard is the correct way up by ensuring the Cuisinart logo can
be read correctly). Attach the pour spout by placing it into the tabs on the splash guard
ring and slide it into place. The splash guard ring can rotate in any direction to easily
add more ingredients.
To Next Page
Loading...
