11
SETTING UP YOUR
SINGLE-SERVE
COFFEEMAKER
INITIAL CLEANING
Perform an initial cleaning before making
your first beverage. Follow these
instructions, without inserting a capsule.
1. Insert charcoal water filter if you haven’t
already. Instructions on page 8.
2. Remove water reservoir from the unit.
3. Fill the reservoir in sink and put back on unit.
4.
If you haven’t already,
plug the power cord
into an independent outlet. Press the power
switch on side of the unit to turn the unit on.
5. Open and close the brew head. Do not add
a capsule.
6. Place mug on the drip tray.
7.
Press the 10 oz. cup button. Light will
flash slowly and the hot water will start
to dispense momentarily
.
8.
The one-time cleaning process is
complete. Discard hot water. Your brewer
is ready to use
.
USING THE SINGLE-
SERVE COFFEEMAKER
Follow instructions in Setting Up Your
Single-Serve Coffeemaker above.
BREWING
1. Remove water reservoir to fill.
2. Add water into the 40-ounce water
reservoir. Replace on unit.
3.
If not already turned on, press the power
switch located on the side of your unit.
Brew buttons will illuminate.
4.
Place mug on the drip tray. The drip tray can
be removed to accommodate travel mugs.
5.
Select a capsule.
NOTE: Do not remove the foil lid or puncture
the capsule.
6.
Open the brew head and place a capsule in
the brewing chamber. Close brew head.
Caution: There are two sharp needles in
the brewing chamber that puncture the
capsule, one above and one below. To
avoid risk of injury, do not put your fingers
in the capsule brewing chamber.
To Next Page
Loading...
Need help?
General
