Culer SOLO - Use & Operation: Power On

www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17
4
Use & Operation
POWER ON
1. Remove tank cap and ll water
tank with 1 gallon of any
drinkable water (tap, hose,
bottled, or distilled) to the
bottom of the ll basket.
NOTE: Do not overll tank. If you see water
in plastic basket, the tank is overlled.
2. Replace cap and tighten until
fully sealed.
NOTE: Unit will not function properly if cap
is not fully tightened.
3. Plug AC/DC power adapter
supply into the power port on
the unit. Plug the three-
pronged plug into an outlet.
4. Press the POWER button at
the top of the unit to turn on
the ash evaporative cooler.
Green light will illuminate.