40 Series Granulators Page 25
Press the granulator start pushbutton and visually check
the direction of rotation of the rotor pulley through the
viewing aperture on the left hand side of the machine.
Correct rotation is as indicated by the arrow nameplates
above the viewing aperture. If the rotor turns in the
opposite direction, reverse any two incoming power
leads to the motor.
Once the rotation direction is correct, the remaining electrical
controls need to be tested as follows:
Press the granulator stop pushbutton and allow the
machine to stop.
For granulators equipped with conveyors, etc., test their
operation also by pressing the appropriate pushbutton.
Check all emergency stop pushbuttons to ensure all
motion stops.
-Notes-
To Next Page
Loading...