Cumulus Machine - Cleaning Cycle; Rinse Cycle

2928
Cleaning cycle
Rinse cycle
1. Pour 1/2 bottle (4 oz) of Cumulus cleaning
solution into the water tank, then ll with clean
water and reinsert.
2. Place your household container on the drip tray,
underneath the spout.
3. Press the brew button. The alert light pulses
blue as the machine pumps water and cleaning
solution into the cooling chamber.
1. Remove and empty the water tank, then ll with clean water and reinsert.
2. Place your household container on the drip tray, underneath the spout.
3. Press the brew button. The alert light pulses blue as the machine pumps water into the cooling chamber.
4. Once the chamber is full, all three beverage indicator lights and the light ring turn white as the machine
pumps and dispenses water into your household container (about 3 or 4 times). When the cycle is
complete, all three beverage indicators turn o and the light ring pulses white.
5. Empty your household container.
6. Repeat steps 1-6 for a total of three times to completely rinse the machine.
7. Exit machine maintenance by pressing and holding the brew button for 5 seconds. All three beverage
indicator lights turn white, the ring light pulses white, and the capsule holder unlocks. Remove the blank
cleaning capsule from the capsule holder and store for future use.
NOTE: If you do not exit the maintenance cycle, the machine will unlock the capsule holder and begin
cooling water automatically after 10 minutes.
4. Once the chamber is full, all three beverage indicator lights and the light ring turn white as the
machine pumps and dispenses water into your household container (about 3 or 4 times). When
the cycle is complete, all three beverage indicators turn o and the light ring pulses white.
5. Empty your household container.
Hand wash the drip tray and water tank in warm, soapy water as needed. Wipe down
machine surfaces with a clean, damp cloth.
Finishing up
Although not recommended, you can skip a maintenance cycle any time the alert light
turns orange by rotating the beverage selector knob to Espresso and holding the brew
button for 5 seconds. The orange light turns o and resets the brew count to zero.
Skipping Maintenance
We recommend running a purge cycle before putting the machine into sleep mode or
long-term storage to ensure there is no water in the system.
Storage