6.3 Electrodes
1) Use the device only with the leads and electrodes provided
by the manufacturer. Use only the electrode placements and
stimulation settings prescribed by your physician or therapist.
2) It is recommended that, at minimum, 40mm*40mm
self-adhering based, square electrodes are used at the
treatment area.
3) Inspect your electrodes before every use. Replace
electrodes as needed. Reusable electrodes may cause
slight skin irritation, lose adhesion and deliver less
stimulation if overused.
To use these electrodes:
1) Attach the electrode to the lead wire.
2) Remove the protective backing from the electrode surface.
Do not throw away the protective backing because it is
reused after the treatment session has been completed.
3) Place the tacky surface to the prescribed skin area by
pressing the electrode firmly against the skin.
To remove your electrodes:
1) Lift the corner of the electrode and gently remove it from the
skin.
Connector for
inserting Lead
wire Pin
Adhesive Pad
Reusable, Self-adhering electrodes
23
To Next Page
Loading...
Need help?
General
