Current Tools 11 - Setup and Operation Guide; Attaching the Cordless Drill

8
SET-UP AND OPERATING INSTRUCTIONS
ATTACHING CORDLESS DRILL TO PULLER
1. Loosen the wing screws and drill attachment strap on the adjustable drill
bracket. Push the bracket to its forward most position.
2. Position the cordless drill chuck on the hex drive shaft of the puller gearbox
and tighten the chuck.
Drill attachment strap must be properly
used during operation. Failure to observe
this warning could result in injury.
WARNING
DANGER
CAUTION
Wing Screws
Drill Attachment
Strap
Adjustable Drill
Bracket
Slide Forward
Hex Drive Shaf
t