6 7
B. Set up the Current Products Corp. bridge
without the mycurtains app
In some instances you may want to establish a mesh network without using
the app or WiFi.
1. Power the Bridge
Find an outlet in a location central to
the drapery that you are installing in the
home. Insert the micro-usb end of the
included power cable into the power port
on the bridge. Plug the other end of the
cable into an outlet [Fig. B1]. Place the
bridge at least 2ft off the ground.
Figure B1; Plug in the bridge.
green and then turn solid red [Fig. B2].
Figure B2; LEDs will ash red and green,
then turn solid red.
Push a tack or paperclip into the hole
in the back of the bridge and press and
hold the button for 5 seconds or until the
button [Fig. B3].
2. Put Bridge in Pairing Mode
Figure B3 - Press and release the
recessed button on the bottom of the
bridge
solid red. After that, the LEDs will stay
red [Fig. B4].
Figure B4; LEDs will ash blue, then turn
solid red.
On any unit that you would like to pair
to the bridge, press and release the
programming button three times without
hearing a beep [Fig. B5]. The E-Wand
should start beeping to indicate it is in
Zigbee Pairing mode.
3. Pair E-Wand
The green LED on the bridge will
paired [Fig. 8.6] The E-Wand will play a
has joined successfully or a failure beep
(Beethoven’s 5th) if it joining was not
successful.
If you have additional devices you would
like to add, repeat Steps 2 & 3.
beep, try putting the unit into pairing
mode again. You have 5 minutes until the
bridge times out of pairing mode.
If the pairing is not successful again, try a
Master Reset on the E-Wand (instructions
on pg. 39 of E-Wand Installation Manual
and User Guide).
Figure B5; Press and release
programming button three times.
Figure B6; Green LED will ash to indicate
successful pairing.
To Next Page
Loading...
Need help?
General
