Programming Guide
Primary/Secondary Pump Syncing (GYRE)
A pump group consists of one Primary pump and at least one Secondary pump. The eFlux Wave
Pump manifold HUB automatically designates Pump 1 as a Primary pump. Pump 2 can
be designated as a Primary pump (controlled independently), or as a Secondary pump (runs oppo-
site of Primary pump). Running two pumps in tandem (Primary/Secondary) automatically synchro-
nizes the pumps in opposite flow modes (WAVE or SURGE), providing stronger wave flow and/or
gyre flow in your aquarium. Note: Primary/Secondary mode is not available using Stream Mode.
To sync your pumps as Primary/Secondary (GYRE Flow):
Step 1: Program Pump 1 into desired mode
Press PUMP 1 key on wireless remote, pump 1 LED will illuminate
on the LED display.
Press WAVE or SURGE mode, mode LED will illuminate
on the LED display.
Adjust both FLOW (Flow) and FRE (Frequency) to the
desired amount using increase/decrease arrow keys.
Step 2: Program Pump 2 as Secondary Pump
Press PUMP 2 key on wireless remote, pump
2 LED will illuminate on LED display.
Press the P/S key on the wireless remote.
P/S will illuminate on the LED display when Pump 2 is
designated as a Secondary pump.
Pumps will now operate in Sync.
Step 3: Program Pump 2 as Primary Pump (Independent)
Press PUMP 2 key on wireless remote, pump 2
LED will illuminate on LED display.
Press the P/S key on the wireless remote.
P/S LED will turn off on LED display when Pump 2 is
designated as a Primary pump.
Pump can now be programmed independently of Pump 1.
NOTE: PUMP 3 is ONLY a Primary Pump (independent) and ONLY in Steady/Stream Mode.
!
"
"
FLOW
FLOW
FREQ
FREQ
SURGE
WAVE
eFlux Wave Pump Kit
P/S
P/S
Page 9
To Next Page
Loading...
Need help?
General
