30
Hints and Tips
Fault Code
Codes
(programme
indicators
light up)
Possible Causes Remedy
P1 + P2 Inadequate water supply • Make sure the water input tap is totally open
and that there is no water cut.
• Close the water input tap, separate the water
input hose from the tap and clean the filter at
the connection end of the hose.
• Restart your machine, contact the service if the
error resumes.
P2 + P4 Error of continuous water input • Close the tap.
• Contact the service.
P3 + P4 The waste water in the machine
cannot be discharged
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the
program cancellation command.
• If the error continues, contact the service.
P1 + P4 Intended water temperature
could not be reached faulty
heater and heater sensor
• Contact the service.
P2 + P3 Alarm is active against water
overflow
• Power off your machine and close the tap.
• Contact the service.
P1 + P2 + P3
+ P4
Faulty electronic card
• Contact the service.
• Repairs should only be carried out by a qualified technician in strict accordance with current
local and national safety regulations. Unauthorised or incorrect repairs could cause personal
injury or damage to the unit.
• Before calling for service, please refer to Hints and Tips to solve some general problems by
yourself.
To Next Page
Loading...
