35
• Use only detergent and rinse aids designed for an automatic dishwasher.
• Other means for disconnection from the supply must be incorporated in the fixed wiring with at least
3mm contact separation in all poles.
• The door should not be left in the open position since this could present a tripping hazard.
• For energy saving, always remember to switch the dishwasher off when you have finished using it. The
dishwasher should not be left unattended when in use.
• Remove the door to the washing compartment when removing an old dishwasher from service or
discarding it.
• During installation, the power supply cord must not be excessively or dangerously bent or flattened.
• Do not tamper with controls.
• The appliance is to be connected to the water mains using new hose sets.
• The maximum number of place settings to be washed is 12.
• The maximum permissible inlet water pressure is 1Mpa, and the minimum permissible inlet water
pressure is 0.04Mpa.
Earthing Instructions
WARNING: THIS APPLIANCE MUST BE EARTHED.
• This appliance is equipped with a mains cable having an equipment-earthing conductor
and an earthing plug.
• The plug must be plugged into an appropriate outlet that is installed and earthed in
accordance with local standards and requirements.
• Improper connection of the equipment-earthing conductor could result in a risk of electric
shock.
• The wires in the cord are coloured as follows:
• Green and Yellow = Earth,
• Blue = Neutral,
• Brown = Live.
• Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed or the plug does not fit correctly.
• Never modify the plug provided with the appliance.
To Next Page
Loading...
