Currys Essentials CID45B16 - Operation; Starting a Wash Cycle; Changing a Programme; At the End of a Programme

26
Operation
Starting a Wash Cycle
Please follow the steps below to start a wash cycle.
1. Ensure the unit is connected to the mains power and the water supply is on (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets
back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close
rmly afterwards.
4. Press the ON/OFF button, the power indicator light will illuminate.
5. Select the wash cycle programme based on the loading and soil requirements. Please refer to
the “Wash Cycle Table”.
6. The indicator light of the selected programme will illuminate.
7. Close the dishwasher door. A click sound should be heard when the door is closed correctly.
Do not slam the door.
8. The wash cycle will begin shortly. The programme indicator will blink normally per second
during operation.
If you open the dishwasher door during the wash cycle and then close it, the dishwasher
will continue the current wash programme after 10 seconds. However, if the door is not
closed correctly after 1 minute, the dishwasher will make an audible sound at 1 minute
intervals.
The condensation strip helps to prevent the risk of steam damage to the worktop
edging above the dishwasher, it is advisable to leave the door closed until you are ready
to unload the crockery. However, you can also open the dishwasher door fully and wait
until the dishes and crockery are cool enough to unload. Do not leave the door partially
open.
Changing a Programme
To change the programme if the wash cycle has already started, follow the steps below.
1. Open the door slightly to check if the unit has dispensed the detergent or detergent tablet.
This will depend on how long the wash cycle will run.
2. If the detergent dispenser lid is already opened, allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press and hold the programme button for 3
seconds to cancel the programme. Then, press the required new programme button and
close the dishwasher door. The unit will start the new wash cycle shortly.
At the End of a Programme
At the end of a programme, the dishwasher will make an audible sound.
CID45B16/A_IB_RC_190828_grace.indd 26 28/8/2019 10:52 AM