ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
2156000-INS-RC
•
PAGE 1
INSTALLATION MANUAL
2156000
Parts List
1 TrailCrusher
™
bumper
8 Socket cap screw, M4
8 Nylock nut, M4
8 Flat washer, M12 x 24mm
8 Lock washer, M12
8 Hex nut, M12
8 Backup washer
Torque Specifications
M4 bolt 16 ft-lbs.
M12 bolt 70 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Torque wrench Socket extension
Box wrench set Socket set
Phillips screwdriver Allen wrench set
Level Flathead screwdriver
Level of Difficulty
Moderate
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Photo
To Next Page
Need help?
General
