To Next PageTo Next Page
Need help?Do you have a question about the curt TRAY-STYLE BIKE RACK and is the answer not in the manual?
General| Category | Racks & Stands |
|---|---|
| Type | Tray-Style Bike Rack |
| Bike Capacity | 2 Bikes |
| Weight Capacity (per bike) | 60 lbs |
| Foldable | Yes |
| Tiltable | Yes |
| Material | Steel |
| Mounting Type | Hitch Mount |
| Lockable | Yes |
| Wheel Holders | Yes |
| Anti-sway Mechanism | Yes |
| Finish | Black Powder Coat |
| Hitch Size | 1-1/4" and 2" |
| Hitch Compatibility | Class 2, 3, 4 |
Insert spacers into hitch shank, then place main body rack and secure with pins and bolt.
Remove outer arm pins, lower side arms flat, then re-insert pins and clips.
Slide support arms onto main body, tighten knobs, and insert set screws.
Slide and tighten long and short locking arms onto the main body rack.
Assemble extension following steps 2 through 4 from the main assembly section.
Insert extension shank into main rack shank and secure with extension bolt sets.
Slide rack shank into receiver hitch and secure with anti-rattle bolt and clip.
Load bikes, raise/lower locking arm onto crossbeam, and tighten.
Tilt carrier down using security pins for access to rear vehicle.
Fold outer side arms up and secure with pins for travel storage.
Fold middle arms, lift rack parallel to vehicle, and secure with pins.
